User manual for the MultiPASS C555.

8-4 Receiving Faxes Chapter 8
Setting the Options for Fax/Tel Mode
If you set Fax/Tel Mode, you can control precisely how the MultiPASS handles
incoming calls by adjusting the following settings:
• Adjust the time the unit takes to check whether a call is from a fax machine or a
telephone (RING START TIME setting).
• Adjust the length of time the unit rings when the call is a voice call (F/T RING TIME
setting).
• Set whether the MultiPASS switches to receive mode after the ring time set in F/T
RING TIME has elapsed (DEFAULT ACTION setting).
n
These options can also be set from the MultiPASS Suite. (1 MultiPASS Suite User’s
Guide
)
■ What Happens When Fax/Tel Mode is Selected
Telephone
Fax
Fax
Sending document
manually
Sending document
automatically
The MultiPASS answers without ringing.
The MultiPASS listens for the fax tone.
(For 8 sec.)
The fax tone
is detected.
The fax tone is not detected.
The document is
received automatically
.
The MultiPASS starts ringing.
Pick up the
handset to talk.
If you don’t pick up the handset
(within 15 sec.).
DEFAULT ACTION
Choose between:
RECEIVE (factory default setting) and DISCONNECT.
DISCONNECT
RECEIVE
(Factory default setting)
(The fax tone is
detected and the
MultiPASS switches
to receive mode.)
The MultiPASS
disconnects the call.
Not all fax machines are capable of sending a
fax tone. For those cases if you set the
DEFAULT ACTION to RECEIVE, the MultiPASS
switches to receive mode automatically and
starts receiving the document. If no document
comes in, it disconnects the call after
approximately 40 seconds.
F/T RING TIME
(Factory default
setting = 15 sec.)
Type of call
Telephone charges
begin for the caller.
RING START TIME
(Factory default
setting
= 8 sec.)