- User's Manual

Preface

iii

Users in the U.S.A.

PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE

EQUIPMENT

A. Location

Supply a suitable table, cabinet, or desk. See Appendix A for the unit’s

dimensions and weight.

B. Order Information

1. Only a single line, touch-tone or rotary telephone set is to be used.

2. Order an RJ11-C modular jack (USOC code), which should be

installed by the phone company. If the RJ11-C jack is not present,

installation cannot occur.

3. Order a normal business line from your telephone company’s business

representative. The line should be a regular voice grade line or the

equivalent. Use one line per unit.

DDD (DIRECT DISTANCE DIAL) LINE

-or-

IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU

COMMUNICATE OVERSEAS

C. Power Requirements

This equipment should be connected to a standard 120 volt AC, three-wire

grounded outlet only. Do not connect this unit to an outlet or power line

shared with other appliances that cause “electrical noise”. Air conditioners,

electric typewriters, copiers, and machines of this sort generate electrical

noise which often interferes with communications equipment and the

sending and receiving of documents.

Canon recommends an individual line following industry standards, e.g. the

2500 (Touch Tone) or 500 (Rotary/Pulse Dial) telephones. A dedicated

extension off a PBX unit without “Call Waiting” can be used with your

MultiPASS. Key telephone systems are not recommended because they send

non-standard signals to individual telephones for ringing and special codes,

which may cause a fax error.