User manual for the MPC5000

Chapter 8 Setup and Other Utilities in the Desktop Manager 8-9
❍ Speed
You set the transmission speed used to receive faxes. The higher the
setting, the faster the fax is received. If you experience problems
when receiving faxes, try a lower speed setting.
❍ Error Correction (ECM)
You select this option to reduce system and line errors when
receiving a fax.With this option selected, the system checks each
incoming fax for lost data.If data has been lost from a portion of a
page, the system receives that portion again after confirming that all
data within that portion can be received successfully.
❍ Ink Saver Mode
You select this option to print documents in the Desktop Manager
using a reduced amount of ink. When using Ink Saver Mode, the
print document may appear less bright or contrasted.
❍ Fax/Telephone Switching Options
You specify these options when your Receive Mode is Fax/Telephone
Switching.
•
Listen Time Before Ringing
When a call is received, the MultiPASS C5000 checks to see if the
call is from a fax machine or a telephone.You use this option to
set the appropriate amount of time (0-30 seconds) to allow the
MultiPASS C5000 to check for the type of call. If your MultiPASS
C5000 does not have enough time to detect the fax tone, it
assumes the call is from a telephone.
•
Ring Time
When your MultiPASS C5000 is set to receive both fax and
telephone calls (FaxTel mode),it rings to inform you of an
incoming telephone call.You use this option to set the
appropriate amount of time (10-45 seconds) the MultiPASS
C5000 will ring. If you do not pick up the telephone within a
certain amount of time,the MultiPASS C5000 stops ringing.
•
Ring Tone
You set the tone of the ring.
Setup and Utilities
Desktop Manager