Printer User Manual

Chapter 4 Sending Faxes With the MultiPASS C635 4-7
If there is no group registered under the one-touch speed dialing button
or the two-digit code, the LCD displays the NO TEL # message. Make
sure you entered the correct number and that the group has been
registered correctly to a speed dial code. (See “Defining a Group Speed
Dial Code” in Chapter 3, Using the MultiPASS Fax Setup Utility.)
If you make a mistake when dialing, press
STOP. You can then try again.
Redialing
Manual
To start dialing again, just press REDIAL. The MultiPASS redials the
previous number you dialed with the numeric buttons. Make sure the
document is in the ADF.
Automatic
The MultiPASS automatically redials if the first attempt at sending fails
(for example, if the line is busy). The unit redials twice, and the time
between redials is two minutes. (These are the default settings.) The
LCD displays AUTO REDIAL and the transaction number while the
MultiPASS is redialing.
If the MultiPASS fails to make a connection after the last redial, it
beeps. The LCD displays
BUSY/NO SIGNAL; try sending again later.
You can change the number of redials (retries) and the time between
redials. The redialing options are set in the Send Fax panel of the
MultiPASS Fax Setup Utility; see “Setting Up Send Fax Options” in
Chapter 3, Using the MultiPASS Fax Setup Utility.
BUSY/NO SIGNAL
TX/RX NO. XXXX
AUTO REDIAL
MPC-C635—USERS MANUAL/V000/06-99
Sending Faxes