User`s guide

97
Advanced Operations
Part 4
 Changingtheprintingorientation
It is possible to print characters with their orientation changed as shown below. And it is also possible to
change the orientation on a page basis or for all pages together after entering characters.
If entered characters are expected to be omitted from the page after the orientation is changed on a page basis,
it is not possible to select such an orientation with the “Page” option. And it is not possible to change the
orientation to “Vertical / Horizontal Character” after entering characters.
Once character data has been entered, the “Vert/Hor char” selection can no longer be made. In this case, you must rst delete all character data,
then make the “Vert/Hor char”selection and re-enter the character data.
Printing might not be performed correctly in some orientations, depending on the settings for the media size and the character size.
ex. Print label tape (12mm wide) as shown below.
1
 Press[A/
A
].
The Orientation display appears.
To change orientation of all pages after entering characters, press [
▼
] or [►] to select
“All”.
•
Confirmthat“Page”isselected.
2
 Press[
▲
]or[
▼
]toselect“Vert/Vertchar”,andthenpress
[Enter].
The character input display appears.•
3
 Press[SetLines].
This is because you are going to input two lines.•
Acheckmark isdisplayednexttothe
currentlyselectednumberoflines.
4
 Press[
▲
]or[
▼
]toselect“2lines”,andthenpress[Enter].
The character input display now shows two lines.•