User`s guide

98
5.3
Replacing the Cutter
If tube or label tape is not fully separated even with forced full cutting ( page 97), the cutter should be
replaced. When replacing the cutter, be sure to replace the cutter receiver at the same time. Contact your
nearest dealer for details on how to obtain a replacement cutter.
If half cuts are too deep even though the cutting depth has been adjusted to the shallowest level, it is possible that the cutter receiver is worn.
CAUTION
Follow procedures!
The cutter is designed so that you cannot touch it directly, but it is possible that
mishandling could expose the blade, creating a risk of injury. Do not attempt any
operation that is not described in this manual. Furthermore, be sure to carefully follow
the procedures described in this manual.
Dispose of the old cutter immediately
Do not keep the old cutter after you have replaced it; dispose of it right away. The
cutter poses a risk of injury to small children, etc.
Discard the removed cutter immediately in compliance with local regulations regarding
the disposal of such items.
1
Turn the power switch off.
Press the “
O
” side.•
2
Open the cover.
3
Pull out the cutter.
Dispose of the old cutter right away.•