Operation Manual

5
Select the [Use SNTP] check box and specify the required settings.
[Use SNTP]
Select the check bo
x to use SNTP for synchronization. If you do not want to use SNTP, clear the check box.
[NTP Server Name]
Enter the IP address of the NTP or the SNTP server. If DNS is available on the network, you can enter a host
name (or FQDN) consisting of alphanumeric characters instead (example: ntp.example.com).
[Polling Interval]
Specify the interval between one synchronization and the next.
6
Click [OK].
7
Restart the machine.
● T
urn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Testing communication with the NTP/SNTP server
● Y
ou can view communication status with the registered server by clicking [Settings/Registration]
[Network
Settings] [Check NTP Server] in [SNTP Settings]. If a proper connection has been established, the result is
displayed as sho
wn below. Note that this operation does not adjust the system clock.
Monitoring the Machine from the Device Management Systems
Y
ou can facilitate the collection and management of various information about networked devices by implementing
device management software, such as iW Management Console
*
, into the network. Information such as device
settings and error logs is retrieved and distributed via the server computer. If the machine is connected to such a
network, iW Management Console searches the network for the machine by using protocols such as Service Location
Protocol (SLP) to gather information from the machine, such as power supply status information. SLP settings can be
Setting Up
74