Operation Manual

0SCJ-081

Configuring Ethernet Settings

Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication

mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX). In general, the machine can

be used without changing the defaults (

Ethernet Driver Settings), but you can change these settings to

suit your network environment.

Tap <Menu> in the <Home> Screen.

Tap <Network Settings>.

If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the

Machine

Select <Ethernet Driver Settings> <Auto Detect>.

Select whether to configure Ethernet settings automatically or manually.

Configuring Ethernet settings automatically

Tap <On>. The machine detects and automatically sets the communication mode and the Ethernet type that can be used.

Configuring Ethernet settings manually

Tap <Off>.

Select the communication mode.

Tap <Communication Mode>

tap <Half Duplex> or <Full Duplex>.

Alternately sends and receives communication data. Select when the machine is connected to a networking device using

half duplex.

Simultaneously sends and receives communication data. Use this setting for most environments.

Select the Ethernet type.

Tap <Ethernet Type>

tap <10BASE-T> or <100BASE-TX>.

Tap <Apply>.

Restart the machine.

Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.

㻟㻤㻠㻌㻛㻌㻣㻟㻡