Operation Manual

1
2
3
4
5
6
TOP
Back Previous Next
5-13
Table of Contents
Index
Advanced Fax Features
Advanced Copy
Features
System Monitor
Reports and Lists
Troubleshooting
Appendix
Copying Problems
Cannot make copies.
Q Have you removed the sealing tape from the
toner cartridge?
A Make sure you remove the sealing tape from the
cartridge. (See “Install Toner Cartridge,” in the
Starter Guide.)
Q Is the toner cartridge installed properly?
A Make sure the toner cartridge is installed properly.
(See “Install Toner Cartridge,” in the Starter Guide.)
A Make sure the front cover is fully closed.
Q Is the document loaded correctly?
A Make sure the document is correctly loaded. (See
Chapter 2, “Document Handling,” in the Basic
Guide.)
Q Does the document meet the requirements for the
machine?
A Make sure you load documents that meet the
requirements for use. (See Chapter 2, “Document
Handling,” in the Basic Guide.)
The alarm sounds* or <MEMORY FULL> appears in the LCD
when making copies.
* MF3240 Only
Q Has an error occurred during transmission or
reception? (MF3240 Only)
A Change to fax mode and check the LCD for an
error message. (See Chapter 11,
“Troubleshooting,” in the Basic Guide.)
Q Is the machine’s memory full?
A Cancel the copy job.
If your machine is MF3240, check remaining
memory. (See “Checking Remaining Memory
(MF3240 Only),” on p. 3-3.)