Service manual

Chapter 3
3-41
F-3-261
3.6.1.10 Removing the Left Frame
0012-1743
1) Remove the left frame [1].
- Remove the cable [2] from the guide.
- 3 screws [3]
F-3-262
3.6.1.11 Removing the Power Supply Shield Plate
0012-1744
1) Remove the cable from the cable guide.
- 1 connector [1]
F-3-263
2) Remove the power supply shield plate [1].
- 9 screws [2]
F-3-264
3.6.1.12 Removing the Fixing Film Unit
0012-1746
1) Remove the fixing cover [1].
- 2 screws [2]
F-3-265
2) Remove the fixing entrance guide [1] by sliding it to the left and right.
- 2 screws [2]
F-3-266
3) Disengage the connector [1] of the power supply board.
4) Remove the grounding springs and the pressure springs [2] on both sides.
5) Remove the pressure plates [3] on both sides.
F-3-267
6) While holding the left and right frames [2] of the Fixing film unit [1], lift
it up at an angle and remove it.
[3]
[1]
[2]
[1]
[3]
[2]
[3]
[1]
[1][1] [1]
[2]
[1]
[1]
[2]
[1]
[2]
[2]
[3]