Service manual

Chapter 3
3-40
F-3-255
3.6.1.5 Removing the rear cover
0012-1737
1) Opening the face-up cover [1], and then lower the fixing pressure release
levers [2] on both sides and release the pressure.
2) Remove the rear cover [3] by sliding it to the rear.
- 4 screws [4]
F-3-256
3.6.1.6 Removing the Scanner Unit
0012-1738
1) Remove the connector [1] and the flat cable [2] on the ECNT board, and
remove the screw [3]. (Remove the flat cable from the core.)
2) Remove the 2 screws [4] and the 2 pins [5] on the right and left sides.
F-3-257
3) Remove the scanner unit [1] by sliding it to the rear and lifting it up.
- 2 screws [2]
F-3-258
3.6.1.7 Removing the top cover
0012-1739
1) Free the 2 claws [1], and remove the top cover [2].
- 2 screws [3]
F-3-259
3.6.1.8 Removing the Right Frame
0012-1740
1) Remove the right frame [1].
- 3 screws [2]
F-3-260
3.6.1.9 Removing the Plate
0012-1741
1) Remove the plate [1].
- 1 connector [2] on the ECNT board
- 3 screws [3]
[2]
[1]
[1]
[4]
[3]
[2]
[4]
[2]
[5]
[4]
[1]
[3]
[1] [2]
[2][3]
[1] [1]
[2]
[2]
[1]