Service manual

Chapter 3
3-16
F-3-98
3.2.1.3 Removing the right cover
0012-1562
1) Remove the 2 screws [1] on the right cover.
F-3-99
2) Remove the right cover [1].
- 2 screws [2]
F-3-100
3.2.1.4 Removong the left cover
0012-1563
1) Remove the 2 screws [1] on the left cover.
F-3-101
2) Remove the left cover [1].
- 2 screws [2]
F-3-102
3.2.1.5 Removing the rear cover
0012-1564
1) Opening the face-up cover [1], and then lower the fixing pressure release
levers [2] on both sides and release the pressure.
2) Remove the rear cover [3] by sliding it to the rear.
- 4 screws [4]
F-3-103
3.2.1.6 Removing the Scanner Unit
0012-1567
1) Remove the connector [1] and the flat cable [2] on the ECNT board, and
remove the screw [3]. (Remove the flat cable from the core.)
2) Remove the 2 screws [4] and the 2 pins [5] on the right and left sides.
F-3-104
3) Remove the scanner unit [1] by sliding it to the rear and lifting it up.
- 2 screws [2]
[1]
[3]
[3]
[2]
[1]
[2]
[1]
[1]
[2]
[1]
[1]
[4]
[3]
[2]
[4]
[2]
[5]
[4]
[1]
[3]