MB2700 series (PDF) User Manual (Mac)

Monitoring Wireless Network Status
Note
• This function is not available depending on the printer you are using.
• When using the printer over the wired LAN, you cannot monitor network status.
1. Start up IJ Network Tool.
2.
Select printer in Printers:.
3.
Select Status on View menu.
The Status screen is displayed and you can check the printer status and connection performance.
1. Signal Level:
Indicates the strength of the signal received by the printer, ranging from 0% to 100%.
2. Link Quality:
Indicates the signal quality excluding the noise while communicating, ranging from 0% to 100%.
Important
• If the indicated value is low, move your printer closer to the wireless network device.
3. Advanced Measurement...
Click to examine the connection performance between the printer and the wireless router. Follow
the instructions on the screen to start measuring and display the status. Measurement takes a few
minutes.
When is displayed in Connection performance between the printer and the wireless
router:, the printer can communicate with the wireless router. Otherwise, refer to displayed
comments and Help for improving the status of communication link, and click Remeasurement.
•
Check that the printer and the wireless router are located within the wireless connectivity
range with no obstacles between them.
•
Check if the distance between the printer and the wireless router is not too far.
If they are too far, move them closer together (within 164 ft. / 50 m).
•
Check that there is no barrier or obstacle between the printer and the wireless router.
In general, connection performance decreases for communications through walls or between
different floors. Adjust the locations to avoid such situations.
379