Operation Manual

Printing on Postcards

This section describes the procedure for postcard printing.

1. Load postcard on the printer

2. Select paper size in the Print Dialog

Select Postcard or Postcard Double from the Paper Size menu.

Important

•

Return postcards can be used only when you print them from the computer.

•

When printing a return postcard, always set the paper size to Postcard Double from your

application software or the printer driver.

•

Do not fold the return postcard. If a crease is formed, the printer will not be able to feed the

postcard properly, and this condition will cause line shifts or a paper jam.

Select Quality & Media from the pop-up menu

Select the media type

For Media Type, select the same paper type loaded in the printer.

Important

• This printer cannot print on postcards that have photos or stickers attached.

• When printing on each side of a postcard separately, you will get cleaner printing if you print the

message side first and then print the address side.

• The paper settings in the print dialog are different, depending on whether you are printing on the

address side or the message side.

To check the current printer settings, select Quality & Media and click Printer Media

Information.

For details about the cassette paper information to be registered in the print dialog and on the

printer, see the following:

• Paper Settings on the Printer Driver and the Printer (Media Type)

• Paper Settings on the Printer Driver and the Printer (Paper Size)

5. Complete the setup

Click Print.

When you execute printing, the data will be printed onto the postcard.

Important

• If you check the Do not show again check box when a guide message is displayed before printing

starts, this will stop any more guide messages from being displayed.

452