User Manual

LV-8235 UST Expand Serial Command Functional Specifications
-30-
8.9.3 CF_AUTOSETUPPCADJ Command
Command “CF_AUTOSETUPPCADJ_%1”[CR]
%1
“ON” ------------------- Set Auto PC function to ON
“OFF” ------------------ Set Auto PC function to OFF
Details
Set/Cancel Auto PC function
This command is available in normal Power ON status.
Note) It is unable to set both PC ADJ. and Auto input to OFF.
If projector receives Auto PC OFF command while Auto input is OFF, it returns
error code “101”.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.9.4 CF_INPUTSEARCH Command
Command “CF_INPUTSEARCH_%1”[CR]
%1
“OFF” ------------------------- Set Auto input operation to OFF
“ON1” ------------------------- Set Auto input operation to On1
“ON2” ------------------------- Set Auto input operation to On2
Details
Set Auto input operation mode.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Note) It is unable to set both PC ADJ. and Auto input to OFF.
If projector receives Auto input OFF command while Auto PC ADJ. is OFF, it
returns error code “101”.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.9.5 CF_AUTOSETUP Command
Command “CF_AUTOSETUP_%1”[CR]
%1 “START” ------------------- Execute Auto Setup
Details
Execute Auto Setup
Note) CF commands does not execute while Auto setup is in process. If the
command is sent during this, projector returns error code “302”
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.9.6 CF_3D SET Command
Command “CF_3DSET_%1”[CR]
%1
“ON” ------------------- Select ON
“OFF” ------------------ Select OFF
Details
Setup 3D function.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]