Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 22 of 41
8.8.6. CF_KYSTNMODE Command
Command “CF_KYSTNMODE_%1” [CR]
%1
“STR” ----------- Set Keystone store Mode to Store
“RST” ----------- Set Keystone store Mode to Reset
Details Set Keystone store Mode. (Only valid when it is in the usual Power On status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9. Lamp Command
8.9.1. CF_LAMPH Command
Command “CF_LAMPH_%1” [CR]
%1 “RST”
Details
Reset total lamp running time. (Only valid when it is in the usual Power On
status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.2. CF_LAMPMODE Command
Command “CF_LAMPMODE_%1” [CR]
%1
“NORMAL” ---------- Set Lamp Mode to Normal
“ECO” ---------------- Set Lamp Mode to Silent
“AUTO” ------------- Set Lamp Mode to Auto
Details
Select Lamp Mode. (Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.10. Sound Command
8.10.1. CF_VOLUME Command
Command “CF_VOLUME_%1” [CR]
%1
“000 – 063” -------------- Directly set Volume value
“UP” ----------------------- Volume setting value +1
“DN” ----------------------- Volume setting value -1
Details
Control Volume setting value. (Only valid when it is in the usual Power On
status)
The same operation as a Remote Control’s turning up/down the volume. Also, the
Command directly sets the volume value.
When setting volume value like Remote Control Unit operation, Sound Mute On
will be canceled. The setting value will be stored in a Projector.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]