Operation Manual

Enter "put<the file name> CONFIG", and then press [ENTER] on your keyboard.
In <the file name>, enter the name of the config file that was entered when the file was
downloaded.
Enter "get reset", then press the [ENTER] key on your keyboard.
ĺ After completing the reset of the printer's network board, the settings are effective.
The settings also become effective by restarting the printer. (Turn off the printer
once, wait at least 10 seconds, and then turn it on.)
Enter "quit", then press the [ENTER] key on your keyboard.
Enter "exit", then press the [ENTER] key on your keyboard.
ĺ Command Prompt closes.
IMPORTANT
When returning to the normal mode (broadcast communication mode)
Change "USE_IP_PORT_NAME" to "NO".
NOTE
If the message <Network Board Error> appears
If the message <Network Board Error> appears in the Printer Status Window after setting the
unicast communication mode, refresh the display of the Printer Status Window.
㻡㻥㻢㻌㻛㻌㻣㻜㻡