Operation Manual

96
Changing the Color and Shooting
Color Swap
You can swap one color in an image for another when recording it. You can
only swap one color.
Choose Y.
● Follow Steps 1 – 2 on p. 54 to choose Y.
Touch .
X The unchanged image and the Color
Swap image will both display.
● The default setting is to change green to
gray.
Specify the color to be swapped.
● Position the center frame so it is filled with
the color you want and touch the frame at
the bottom left of the screen.
X The specified color will be recorded.
Specify the target color.
● Position the center frame so it is filled with
the color you want and touch the frame at
the bottom right of the screen.
X The specified color will be recorded.
Specify the range of colors to be
swapped.
● Touch op to change the range of colors
to be retained.
● Choose a negative value to limit the range
of colors. Choose a positive value to
extend the range of colors to similar colors.
● Touching Ú restores the shooting screen.
• Using the flash may cause unexpected results in this mode.
• Under some conditions, the image may appear coarse.