Service manual

Chapter 4
4-22
8) Remove the original sensor (vertical scan direction) [1].
- connector [2], 2 pcs
F-4-53
4.4.7.2 Removing the Original Sensor (Horizontal Scan
Direction)
0017-8505
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
1) Open the copyboard cover (or ADF).
2) Remove the copyboard glass.
3) Detach the cover [1].
- Screw [2], 1 pcs
F-4-54
4) Disconnect the connector [1] from the reader controller PCB, and then re-
move the harness from the edge saddle [2].
5) Remove the original sensor [3] together with the mount.
- Screw [4], 2 pcs
F-4-55
6) Remove the harness from the edge saddle/clamp [1], and then disconnect
the connector.
7) Remove the original sensor [2].
F-4-56
4.4.8 Reader Heater (option)
4.4.8.1 Removing the Reader Heater (Right)
0017-8511
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
1) Open the copyboard cover (or ADF).
2) remove the copyboard glass.
3) Detach the heater cover [1].
- Screw [2], 1 pcs
F-4-57
4) Remove the screw [1].
5) remove the reader heater (right) [2].
- wire saddle [3], 1 pcs
- connector [4], 1 pcs
F-4-58
4.4.8.2 Removing the Reader Heater (Left)
0017-8513
iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i
1) Open the copyboard cover (or ADF).
2) Detach the reader front cover.
3) Remove the glass retainer.
4) Remove the ADF reading glass.
[1]
[2]
[2][1]
[3]
[1] [2] [4]
[1]
[2]
[2][1]
[3] [1][4][2]