User Guide

Chapter 1
27
through the installed edge saddle, and then route the
harness to the front of the host machine through the
hole [3].
F-1-66
9) Pass the heater harness [1] through the wire saddle
[2], and then connect it to the connector (J17) [3] on
the power supply PCB.
F-1-67
10) Install the delivery tray. (2 screws)
When reinstalling the delivery tray, be careful not to
damage the paper holder.
11) Attach the upper-right cover of the host machine.
(1 screw)
12) Attach the lower-right cover of the host machine.
(5 screws)
13) Attach the rear cover of the host machine. (4
screws)
14) Close the front cover of the host machine.