Operation Manual

Remove the trim waste
Introduction
This section describes how to remove trim waste from Booklet Finisher- A1 when Inner
Booklet Trimmer-A1 is installed.
#
IMPORTANT
•
Take care when handling the optional equipment that is attached to the machine.
When an optional unit's cover is opened to replace a staple cartridge, discard the
punch waste, discard the trim waste, or clear paper or staple jams, prints may still
be output if other optional units are operating normally and are not involved in
the paper or staple jam removal procedure.
•
When the trim waste tray is full, you cannot make copies or prints using the
trimming options.
Remove the trim waste
1.
Open the front cover of the finisher.
2.
Pull out the trim waste tray.
Chapter 9 - Paper, toner, and staples296
Remove the trim waste