Setup Guide

Using the System Options/MEAP Applications

Installing by Connecting

This Machine to an

Outside Network

If the machine is connected to an external

network, you can install system options/MEAP

applications via a delivery server. Install using one

of the following procedures.

• See “Using the Touch Panel Display to Install (Delivery),” on p. 74.

• See “Using the Remote UI to Install (Delivery),” on p. 75.

• To check that the transmission with the delivery server is

properly operating, if necessary, perform a transmission test

before installation. (See “Using the Touch Panel Display,” on p. 82,

and “Using the Remote UI,” on p. 84.)

• Prepare the License Access Number certificate that was included

in the package.

• When you install MEAP applications, you must start the

application before using the MEAP application. (See “Starting the

MEAP Applications,” on p. 79.)

Using the Touch Panel

Display to Install (Delivery)

You can install system options/MEAP applications in the

machine using the touch panel display.

• The maximum number of MEAP applications that can be

installed is 19.

• The maximum amount of hard disk space allocated to install

MEAP applications is 1 GB.

• There may be other system requirements for installation,

depending on the MEAP application. For more information, see

the manual provided with each MEAP application.

Press (Settings/Registration)→ [Management

Settings] → [License/Other] → [Register/Update

Software].

Press [Install Applications/Options].

Press [License Access Number].

Enter the license access number four digits at a

time.

Enter four digits of the license access number → press [OK].

Repeat this step four times to enter a total of 16 digits for the

License Access Number.

Press [Start].