imagePROGRAF TM-300 series (PDF) User Manual (Windows)

Performing/Changing Wi-Fi Settings

Follow the procedure below to perform/change Wi-Fi settings.

Important

• Enable Easy wireless connect (Cableless setup) before performing printer setup. (Not required if you

change the IP address.) For details, search for "NR049" on your printer's online manual and see the

page shown.

• If you use a printer over the Wi-Fi, we highly recommend you perform security settings for Wi-Fi

network using WPA/WPA2 from the viewpoint of security.

Note

• For some models, you can perform network setup for a USB connected printer using IJ Network Device

Setup Utility. Select USB on Switch View under the View menu to display printers.

Start up IJ Network Device Setup Utility.

Check the displayed message and select Yes.

Select Printer Network Setup on the displayed screen.

Detected printers are listed.

Select printer to perform/change settings from printer list.

Select the printer with Wi-Fi displayed on Connection Method and Available or Requires Setup

displayed on Status to perform settings.

You can perform settings for a printer with Available or Requires Setup not displayed on Status via

USB connection.

To perform setup for a USB connected printer, select USB from the pulldown menu on the toolbar and

select the printer to perform/change settings.

Select Network Settings... on Printer Settings menu.

The Confirm Printer Password screen appears.

For more on the password, refer to Administrator Password.

Note

•

Clicking the icon allows you to perform/change settings.

•

If you select a USB connected printer on step 4 and the selected printer is compatible with wired

LAN, the screen below appears after the Confirm Printer Password screen appears

303