imagePROGRAF TM-200 series (PDF) User Manual (Mac)

Loading Sheets in the Printer

Follow these steps to load sheets in the printer.

Important

• One sheet of paper can be loaded in the feed slot at a time. Do not load more than one sheet at a time.

This may cause paper jams.

• Before feeding paper or printing, make sure the sheet is flat against the roll paper cover. The sheet may

jam if it curls before feeding or printing and the trailing edge drops toward the front.

• Paper that is wrinkled or warped may jam. If necessary, straighten the paper and reload it.

• Load the paper straight. Loading paper askew will cause an error. (See "1317.")

Note

• Before loading cut sheets, check whether or not the inside of the top cover or the output guide is soiled.

If these areas are dirty, we recommend cleaning them in advance. (See "Cleaning Inside the Top

Cover.").

• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.

Select sheets as the paper source.

• If a print job was received

Sheets are automatically selected, and the media type and size specified by the print job are

shown on the operation panel.

Tap OK and Load paper.

• If no print job was received

1. Tap Load paper or Replace paper.

Tap Load cut sheet or Replace cut sheet.

Note

•

If the Home screen does not appear, press the HOME button.

Note

•

If any paper has been advanced that will not be used, a message is shown requesting you to

remove it.