iPF825 User Manual Ver.1.00

Cutting the Leading Edge of Roll Paper Automatically

If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, set Trim

Edge First to Automatic or On on the Control Panel to have the printer cut the leading edge to make the edge straight after

you load a roll.

Trim Edge First offers the following options.

•

Automatic

If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 40 mm (1.6 in) or more when you

load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed. The edge

is not cut if the unevenness is less than 40 mm. However, paper may sometimes be cut, depending on the state of the

leading edge.

•

Off

The edge is not cut and scraps are not removed. This setting is Off for

most types of paper, by default. For more infor-

mation, see the Paper Reference Guide. (See "Types of Paper.")

→P.623

•

The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut off from the leading

edge

varies depending on the paper type. For more information, see the Paper Reference Guide. (See "Types of Pa-

per.")

→P.623

Note

• If

you print on paper that has an irregular width, set Skew Check Lv. to Loose for a higher skew detection

threshold or to Off to disable skew detection. However, if paper is loaded askew when detection is Off, note

that paper jams or Platen soiling may occur.

Follow these steps to change the Trim Edge First setting.

1. Press the Menu button to display MAIN MENU.

Handling Paper

Handling rolls

iPF825 Cutting the Leading Edge of Roll Paper Automatically

659