iPF605 User Manual
Messages regarding paper
Insufcient paper for job
Cause Corrective Action
Follow the steps below to replace the roll.
1. Remove the roll.
( → P .1 17)
( → P .1 18)
( → P .1 19)
2. Load a roll with enough paper left.
( → P .1 12)
( → P .1 14)
( → P .1 15)
3. If no barcode was printed on the roll, specify the
paper type.
( → P .1 10)
4. Select the paper length, unless a barcode was
printed on the roll and you have deactivated
automatic detection of the remaining roll paper .
( → P .1 1 1)
Hold down the Stop button for a second or more to
cancel printing.
The printer has received a print job longer than the
amount of roll paper left.
Press the Online button to resume printing.
However , the roll paper may run out during the
print job and you may not be able to print all of the
document.
This paper cannot be used.
Check supported paper sizes.
Cause Corrective Action
Paper that is too large for the printer has been loaded. Load paper of the correct size.
( → P .106)
Paper that is too small for the printer has been
loaded.
Load paper of the correct size.
( → P .106)
Roll printing is selected.
Cause Corrective Action
Load a roll and try printing again.Y ou have attempted to print a test print sheet or
other printer status information on a roll, but no roll
is loaded.
T o print on a sheet instead, hold the Stop button for
more than a second to cancel printing, load a sheet,
and then print.
( → P .90)
540 Error Message