User Manual
Table Of Contents
- Contents
- Chapter 1 Preface
- Chapter 2 Explore the print system
- Chapter 3 Explore the ease of operation
- Chapter 4 Start the print system
- Chapter 5 Adjust the control panel
- Chapter 6 Prepare the system
- Chapter 7 Prepare the jobs
- Chapter 8 Plan the workload
- Chapter 9 Plan the jobs
- Chapter 10 Print the jobs
- Chapter 11 Keep the colour quality high
- Chapter 12 Perform colour adjustments
- About colour adjustments
- Automatic colour mismatch correction
- Create a trapping preset
- Perform a manual shading correction
- Adjust CMYK curves for a job
- Adjust CMYK curves for a media family
- Correct the colour tones with the ACCT function
- Register the custom media for automatic gradation adjustment
- Create media families and output profiles
- Chapter 13 Perform media adjustments
- Chapter 14 Maintain the print system
- System configuration and maintenance
- Refill toner and staples
- Consumables
- Check the filling level of the toner cartridge
- Replace a toner cartridge
- Check the filling level of the waste toner container
- Replace the waste toner container
- Check the filling level of the staple cartridge
- Replace the staple cartridge in the staple unit of the stacker / stapler
- Replace the staple cartridge in the saddle-stitch unit of the stacker / stapler
- Remove staple and punch waste
- Clean print system parts
- Cleaning tasks and procedures
- Clean the control panel
- Clean the glass plate area
- Clean the automatic document feeder scanning area
- Clean the scanning sensors
- Clean the rollers of the automatic document feeder
- Clean the inside of the print module
- Clean the corona assembly wires
- Clean the clean roller
- Refresh the fixing roller
- Maintain print system parts
- Install system software
- Read the counters
- Chapter 15 Help
- Chapter 16 References
- Index
Check and prepare transparencies before loading
Transparencies and other highly transparent media have a different front and back side. Make
sure you load transparencies so that the print system prints the front side.
IMPORTANT
• Do not load transparencies while the print system prints. This can cause a paper jam.
• Only use transparencies intended for your print system. Other transparencies can damage the
print system.
• Only hold the edges of the sheets and avoid to touch the print surface.
• When transparencies stick together, fan the stack very well and do not load more than 100
sheets. Use new transparencies when a paper jam occurs.
• Take printed transparencies immediately from the output tray to avoid folded transparencies.
This can cause a paper jam.
For more information, see:
Media specifications
on page 306
Check and prepare media before loading
on page 155
Procedure
1.
Make sure the media specifications match the paper tray specifications.
Only use A4 / LTR or A4R / LTRR transparencies. (See
Paper input specifications
on page 293)
2.
Remove the packaging and check that the transparencies are in good condition.
After you finish
Tightly rewrap the remaining media in the original package, and store the package in a dry place,
away from direct sunlight.
Check and prepare transparencies before loading
Chapter 10 - Print the jobs
159
imagePRESS C10000VP