User Manual

14
4. Optional Products
The following options can be purchased and used on the DR-7090C, if they are necessary. Contact your sales representative.
Stamp Unit
The stamp unit affixes a stamp on document pages that are
scanned using the feeder. The application can be used to turn
stamping on or off.
The stamp is a circle that has a diameter of about 0.1" (3 mm),
with a cross in the center. It is stamped on the scanned side of
the document page, approximately 0.4" (10 mm) from the
trailing edge of the document page.
Hint
• The stamp pattern is fixed and cannot be changed.
• When scanning both sides of a document, the sides that are
stamped will differ depending on the Single Pass Duplex setting
of the scanner’s user mode settings. When the Single Pass
Duplex setting is ON, only the front side of the document is
stamped. When the Single Pass Duplex setting is OFF, both sides
of the document are stamped.
• The cross in the center of the stamp rotates during stamping.
Stamp
Position
Stamp
Position