User Manual

Back Previous Page Next Page

Contents

DR-2010C / DR-2510C

Remove the jammed document from the document feeding side or

document ejecting side.

IMPORTANT

Make sure to pull the document out carefully, without applying too much force. If

the jammed paper tears while you are pulling it out, make sure to remove any

remaining pieces from inside the scanner.

Close the front unit by gently pushing it up on both sides until clicks into

place. Make sure that the front unit is completely closed by pushing until

you hear a click.

After removing the jammed paper, check to see if the last page was

scanned correctly, and then continue scanning.

NOTE

If a paper jam occurs when [Rapid recovery system] is enabled in the [Others] tab

of the ISIS/TWAIN driver settings dialog box, the image data of the document is not

saved and scanning stops. This allows you to continue scanning from the

document that caused the paper jam after the paper jam is fixed.