Scanner User Manual

6
Installation Location
For operation, maintenance, and ventilation, make sure that there is
enough space around the scanner, as shown in the illustration above.
Avoid placing the scanner in the following places. It may cause a
malfunction and adversely affect the scanner or your computer.
● Places exposed to direct sunlight
If installation in such places is unavoidable, provide a curtain or
similar object to shade the scanner.
● Places subject to dust and fumes
Dust and cigarette fumes adversely affect the components inside
the scanner.
● Near running water, a heat source, water vapor, or in an area, such
as a laboratory exposed to ammonia gas, paint thinner, or other
volatile chemicals
● Places subject to excessive vibration and shock
● Places subject to rapid changes in temperature or humidity
Condensation occurring inside the scanner may impair image
quality. Place the scanner in a room that is within the following
range:
Room temperature: 50°F to 90.5°F (10°C to 32.5°C)
Relative humidity: 20% to 80% RH
Use the recommended operating environment for the ink cartridge
when using the imprinter.
● Near electronic equipment or heavy equipment that generates a
strong magnetic field, such as a speaker, TV, and radio
Power Supply
● Connect only to a power outlet of the rated voltage and power
supply frequency (either 120 V, 60 Hz or 220-240 V, 50/60 Hz,
depending on your region).
● Make sure that the scanner is connected to an independent power
outlet. Do not plug the scanner into an outlet shared with another
device. If you use an extension cord, make sure that the extension
cord is rated for the current requirements of the scanner.
● If you are unsure of anything relating to the power supply, contact
your local authorized Canon dealer or service representative for
further information.
● Never place an object on top of the power cord or step on the power
cord.
● Never bundle the power cord or wrap the cord around an object,
such as a table leg.
● Do not tug on the power cord. When you remove the power cord,
grip it by the power plug head.
● Keep the area around the power outlet free of obstacles.
Moving the Scanner
When you move the CR-190i, hold it firmly with both hands and carry
it carefully. Do not hold the scanner by the Eject Stopper. The scanner
weighs approximately 18.5 lb (8.4 kg).
WARNING
When moving the scanner, be sure to turn OFF the power and
remove any cables. If the cables are not removed before moving
the scanner, you may damage the plugs or connector by forcibly
pulling them out.
3.9" (100 mm)
27.8" (706 mm)
5" (125 mm)
14" (356 mm)
18.3" (466 mm)