Scanner User Manual

ManualsBrandsCanon ManualsScannerIMAGEFORMULA CR-190I

Checking Your Operating Environment

The following computer system requirements are recommended for

using the CR-190i.

Operating Systems:

• Microsoft Windows XP (32bit) SP3 or later

• Microsoft Windows XP (64bit) SP2 or later

• Microsoft Windows Vista (32/64bit) SP1 or later

• Microsoft Windows 7 (32/64bit)

Specifications:

• CPU: Intel Core2 Duo 3.0 GHz or faster

• Memory: 1 GB or more

• USB 2.0 interface

Interface Cable

• Use the cable provided or a Hi-Speed USB 2.0 interface cable to

connect to the computer’s USB port.

IMPORTANT

• If you use the USB interface that was provided as standard with

your computer:

• Use the most recently available USB 2.0 driver provided by

Microsoft. Contact your local authorized Canon dealer for more

detailed information.

• Not all USB interfaces provided as standard with personal

computers are guaranteed. Contact your local authorized Canon

dealer for more detailed information.

• Scanning speeds are slower if your computer’s standard USB

interface is USB 1.1.

• You should use the USB cable originally bundled with the scanner

or a Hi-Speed USB 2.0 compatible cable.

• If the CPU, memory, interface card, and other specifications do not

satisfy the installation requirements, the scanning speed may be

greatly reduced and transmission may take longer.

• Even if the computer satisfies the recommended specifications, the

scanning speed may vary, depending on the scan settings.

Installing the Scanning Utility

Follow the instructions below to install the Scanning Utility and the

dedicated driver.

NOTE

The dedicated scanner driver is installed after the Scanning Utility

has been installed.

Turn ON your computer, and log on to Windows.

IMPORTANT

Be sure to log on as the Administrator.

Insert the setup disc into the CD-ROM drive.

This manual assumes that “D” is assigned to your CD-ROM drive.

Click [Start], and then click [All Programs].

The procedure in Windows XP/7 is different from the ones

described in this manual. Refer to the Windows XP/7 “Help and

Support Center” to select [Run].