imageCLASS MF6500 Series Advanced Guide

1
2
3
4
5
6
7
8
TOP
Back Previous Next
3-5
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
Network
Remote UI
System Monitor
Reports and Lists
Troubleshooting
Appendix
Interface Settings
Ethernet Driver
You can specify the communication method and Ethernet
connection type.
1. Press [Additional Functions].
2. Use [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
3. Use [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4. Use [ ] or [ ] to select <ETHERNET
DRIVER>, then press [OK].
5. Confirm that <AUTO DETECT> is displayed,
then press [OK].
6. Use [ ] or [ ] to select the desired
detection method, then press [OK].
<AUTO>: Automatically determines the communication mode
(Half duplex/Full duplex) and Ethernet type (10Base-T/100Base-
TX). Skip to step 11.
<MANUAL>: You have to manually specify the communication
mode and Ethernet type.
NOTE
If you reconnect the network cable (for example, reconnect the
cable to a different Ethernet hub) with the power on, the Auto
Detect function will not work even if you set <AUTO DETECT> to
<AUTO>. (Connect the cable with the power off.)
7. Confirm that <DUPLEX> is displayed, then
press [OK].
8. Use [ ] or [ ] to select the desired
communication method, then press [OK].
<HALF DUPLEX>: Sends and receives alternately.
<FULL DUPLEX>: Sends and receives simultaneously.