Service manual

Chapter 15
15-10
15.2 Service Mode Table
15.2.1 Bit Switch Settings
0007-7212
A bit switch consists of 8 bits, used for registering/setting an item. The switch is configured as follows, and each bit
is always either '0' or '1':
F-15-9
Do not change service data marked "not used" for its initial setting.
#SSSW-SW01: error/copy control
T-15-1
[Bit 0]
Use it to specify whether or not to generate a service error code. If set to '1' a service error code will be indicated on
the report.
[Bit 1]
Use it to specify whether or not to generate an error dump list. When set to '1' an error dump list will be attached to
Bit Function 1 0 Factory
setting
0 service error code output do not output 0
1 error dump list output do not output 0
2 not used - -
3 not used - -
4 not used - -
5 not used - -
6 not used - -
7 user setting restriction do not impose impose 0
SW01
00000000
Bi t 7 Bi t 6 Bi t 5 Bi t 4 Bi t 3
Bi t 2
Bi t 1
Bi t 0