User Guide

2-8
Chapter 2 Setup
IMPORTANT
Observe the following when connecting the scanner with other
devices in a “daisy chain”.
• The SCSI ID of the scanner is set to “SCSI ID = 2” by default.
When using a daisy-chain configuration with other SCSI
devices, set the DIP switches so that SCSI ID numbers are not
duplicated in the system.
• The scanner incorporates a SCSI terminator which is
permanently set to ON. When using a daisy-chain
configuration with other SCSI devices, make sure that the
scanner is connected as the last device in the chain. Set the
terminators of all other devices to OFF.
DIP Switches
Default Position (SCSI ID=2)