Operation Manual

Table Of Contents

0ALJ-084

Setting IPv4 Address

The machine's IPv4 address can be either assigned automatically by a dynamic IP addressing protocol, such as

DHCP, or entered manually. When connecting the machine to a wired LAN, make sure that the connectors of

the LAN cable are firmly inserted into the ports (

Connecting to a Wired LAN). You can test the network

connection if necessary.

Setting IPv4 Address

Testing the Network Connection

Press .

Use / to select <Network Settings>, and press .

If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press . Logging on to the

Machine

Select <TCP/IP Settings> <IPv4 Settings> <IP Address Settings>.

Configure IP address settings.

Select to automatically assign an IP address via a protocol such as DHCP. When <Auto Acquire: On> is displayed, automatic

addressing is enabled.

Select to configure the IP address settings by manually entering an IP address. In order to select this option, <Auto Acquire>

must be set to <Off>.

Select when you want to view the current IP address settings.

Automatically assigning an IP address

Select <Auto Acquire> <Select Protocol>.

Select <DHCP>, <BOOTP>, or <RARP>, and press .

NOTE:

If you do not want to use DHCP/BOOTP/RARP to assign an IP address

Select <Off>. If you select <DHCP>, <BOOTP>, or <RARP> when these services are unavailable, the machine will waste

time and communications resources searching the network for these services.

Check that <Auto IP> is set to <On>.

If <Off> is selected, change the setting to <On>.

Setting IPv4 Address

㻟㻟㻥㻌㻛㻌㻢㻣㻢