Specifications

Check Dial Tone Before Sending
Select whether to check the dial tone before a fax number is dialed.
Off
On
Specify settings for receiving faxes.
ECM RX
Enable or disable error correction mode (ECM). ECM checks for fax data errors and corrects them. To reduce errors on sent faxes,
see
ECM TX.
Off
On
NOTE
ECM must be enabled on both the machine and the other fax device because error check is performed on both the sending
and receiving devices.
Even when ECM is enabled, errors may occur due to telephone line conditions.
It may take a longer time than usual to process data when ECM is enabled because the error check and corrections are
performed while the data is transmitted.
Incoming Ring
<Print Position>
Specifies the position to print the terminal ID information in the sent fax. Select <Inside Image Area> to print the
information inside the image area, or <Outside Image Area> to print the information outside the image area.
<Mark Number as>
Adds the "FAX" or "TEL" mark in front of the fax number registered for the machine (
Registering the Fax Number
and Unit Name). Select <TEL> to indicate that the notified number is a telephone number.
*1
<Fax Settings> <TX Function Settings> <Check Dial Tone Before Sending>
<On>
RX Function Settings
<Fax Settings> <RX Function Settings> <ECM RX> <On>
*1
㻠㻥㻥㻌㻛㻌㻢㻣㻢