Camcorder User Manual

46  Smart AUTO Mode
• When recording at maximum advanced zoom, the video quality is
equivalent to high definition.
• In mode, you can also set 7 8 [Zoom Speed] to one of three
constant speeds (3 is the fastest, 1 the slowest).
• When [Zoom Speed] is set to [I Variable], the zoom speed will be
faster in record pause mode than when actually recording, except when
pre-recording (0 63) is activated.
Quick Start Function
When you close the LCD panel with the camcorder on, the camcorder
enters the standby mode. In standby mode the camcorder consumes
only about 1/3 the power used when recording, saving energy when
you are using a battery pack. Additionally, when you open the LCD
panel, the camcorder is ready to start recording in approximately
1 second*, allowing you to record the subject right away.
* The actual time required varies depending on the shooting conditions.
1 With the camcorder on and in a recording mode, close the LCD
panel.
A beep will sound and the green ON/OFF (CHG) indicator will change
to orange to indicate the camcorder entered standby mode.
2 When you wish to resume recording, open the LCD panel.
The ON/OFF (CHG) indicator turns back green and the camcorder is
ready to record.
IMPORTANT
• Do not disconnect the power source during standby mode (while the
ON/OFF (CHG) indicator is lit in orange).
NOTES
• The camcorder will not enter standby mode if the LCD panel is closed
while the ACCESS indicator is on or flashing, or while a menu is being
displayed. The camcorder may also not enter standby mode if the LCD
panel is closed when the battery charge is too low. Check that the ON/
OFF (CHG) indicator changes to orange.
Operating modes: