User Guide

41
1Using Full Auto
5
Take the picture.
¡ Compose the shot and press the
shutter button completely.
s The captured image will be displayed
for about 2 sec. on the LCD monitor.
¡ To view the images recorded on the
CF card, press the <x> button.
(p.103)
¡ While focusing with <AF>, do not touch the focusing ring at the front of
the lens.
¡ If you want to zoom, do it before focusing. Turning the zoom ring after
achieving focus may throw off the focus.
¡ When the CF card becomes full, the CF Full warning “FuLL CF” will
appear in the viewfinder and on the LCD panel and shooting will be
disabled. Replace the CF card with one that has room.
¡ If something obstructs the built-in flash from popping up, “Err 05” will
blink on the LCD panel. If this happens, turn the <4> switch to <2>
and set it back to <1>.
¡ Using a non-Canon lens with an EOS camera may not result in proper
camera or lens operation.
¡ When focus is achieved, the focus and exposure setting will also be
locked.
¡ If the focus confirmation light <o> blinks, the picture cannot be taken.
(p.70)
¡ Multiple AF points may flash simultaneously in red.This indicates that
focus has been achieved at all those AF points.
¡ In the Basic Zone modes (except <3> <5> <7>), the built-in flash
will pop up and fire automatically in low-light or backlit conditions. To
retract the flash, push it back down.
¡ You can disable the beeper from sounding when focus is achieved. (p.90)
¡ The image review time after image capture can be changed with the
menu’s [x Review time] setting. (p.100)
¡ If you want to select the AF point to be used for focusing, set the Mode
Dial to <d>, then follow “Selecting the AF Point” (p.67) to select the AF
point.