Owner's Manual

52
Dust on the document sensors. Clean the document sensors. (➞ 44)
U18 Rema i nd Doc .
✕✕✕✕✕✕✕✕
Double-feed occurred. Remove the jammed pages. (➞ 39)
U23 Double Feed
✕✕✕✕✕✕✕✕
Front door is open. Close the front door.
U30 F r on t Doo r
✕✕✕✕✕✕✕✕
ADF door is open. Close the ADF door.
U31 ADF Doo r
✕✕✕✕✕✕✕✕
Imprinter (top door) is open. Close the imprinter door.
U32 Top Doo r
✕✕✕✕✕✕✕✕
Document cover is open. Close the document cover.
U35 Doc .Cover
✕✕✕✕✕✕✕✕
Service error*. Switch off the scanner, unplug the
power cord, and call for service.
Interface board not installed. Install the interface board.
F ✕✕ Ca l l Se r v i ce
✕✕✕✕✕✕✕✕
U50 No I ⁄ F Boa r d
✕✕✕✕✕✕✕✕
Document was skewed. Open the ADF and remove the
stopped document. (
➞ 39)
U20 SkewError
✕✕✕✕✕✕✕✕
Originals are still in the scanner. Remove all documents in the ADF.
Error Message Table
Possible Cause RemedyLCD
Rollers are dirty. Clean the rollers. (➞ 41)
***
Wa r n
Clean Ro
ing
***
ller
Rollers require replacement. Replace the rollers.
***
Wa r n
Rep l ace
ing
***
Ro l l e r
Double-feed occurred. Check the ADF paper feed path.
***
Wa r n
Db l Feed
ing
***
Ocu r red
Dust on the paper detection sensor. Clean the paper detection sensor.
(➞ 44)
U11 JAM
✕✕✕✕✕✕✕✕
Page has jammed. Remove the jammed page. (➞ 39)
Page has jammed. Remove the jammed page. (➞ 39)
U12 JAM
✕✕✕✕✕✕✕✕
* If you see the call-for-service error “F41 Call Service” displayed in the LCD, check the position of the metal
clamp under the scanner. (➞ 10)
Troubleshooting
U14 JAM
✕✕✕✕✕✕✕✕
U16 JAM
✕✕✕✕✕✕✕✕