User Manual

Playback
Basic Functions
31
5 Push the joystick ( ) towards /
to begin the playback.
D URING PLAYBACK
6 Push the joystick ( ) towards
/ again to pause the playback.
7 Push the joystick ( ) towards to
stop the playback.
T O ADJUST THE VOLUME
1 Press .
2 Select ( ) [ SPEAKER
VOLUME] and adjust ( ) the
volume.
• The sound from the built-in speaker
will be muted when you close the LCD
panel or while the STV-250N Stereo
Video Cable is connected to the AV
terminal.
• If you turn off the volume completely,
the icon will change to .
3 Press to close the menu.
S PECIAL P LAYBACK M ODES
To operate the special playback modes
use the buttons on the wireless
controller*. There is no sound during the
special playback modes. To return to
normal playback, push the joystick ( )
towards / or press on the
wireless controller*.

Fast Playback: Push the joystick ( )
towards or ( ) towards . Hold
the joystick pressed down to rewind/fast
forward the tape while continuing the
playback. You can also press and hold
or on the wireless
controller*.

Reverse Playback: During normal
playback press .

Frame Reverse/Advance: During playback
pause press / . Keep pressed
for continuous frame-by-frame playback.

Slow Playback: During normal or reverse
playback press .

Double Speed Playback: During normal or
reverse playback press .
*The wireless controller is included only
with the .
NOTES
You can display the date and time of the
recording ( 53).
During some special playback modes, you
may notice some video problems (blocky video
artifacts, banding, etc.) in the playback picture.
To protect the tape and video heads, the
camcorder will enter the stop mode ( ) if left in
playback pause ( ) mode for 4 minutes 30
seconds. To resume the playback push the
joystick ( ) towards / .
Returning to a Pre-marked Position
If you wish to return to a particular scene
later, mark the point with the zero set
memory and the tape will stop at that
point when you rewind/fast forward the
tape.
1 While recording or during playback,
press on the
wireless controller at the point you
wish to return to later.
• The time code changes to
“0:00:00 ”.
• Press again to
cancel the memory.
2 If you marked the zero memory
while recording, set the camcorder
to mode. If you marked
the zero memory during playback,
press .
3 Press to locate the zero mark.
• If the tape counter shows a negative
number, press instead.
• appears and the camcorder
rewinds/fast forwards the tape.
FUNC.
FUNC.
PLAY
REW FF
SLOW
(8)
ZERO SET MEMORY
ZERO SET MEMORY