DC50/220/230 DVD Camcorder Instruction Manual

102
Trouble?
Memory Card Operation
Printing
List of Messages
Problem Solution
Memory card cannot be
inserted.
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
28
Memory card cannot be
recorded.
Memory card is full. Erase still images to free some space or
replace the memory card.
73
Memory card was not initialized. Initialize the memory card. 76
The folder and file numbers have reached their maximum value.
Set [FILE NOS.] to [RESET] and insert a new memory card.
50
Memory card cannot be played
back.
Insert a memory card. 28
Set the camcorder to . 41
Make sure the memory card is selected as the media for still
images.
37
Image cannot be erased. Image is protected. Cancel the protection. 75
“ ” flashes in red. Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Initialize the memory card if flashing
persists.
76
Problem Solution
The printer is not operating
even though the camcorder
and printer are correctly
connected.
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to mode and restore the connection.
–
Message Explanation
SET THE TIME ZONE,
DATE AND TIME
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
32
CHANGE THE BATTERY
PACK
Battery pack is exhausted. Replace or charge the battery pack. 23
CANNOT ENTER THE
STANDBY MODE NOW
The camcorder cannot enter the Quick Start standby mode while
the disc is being recognized after first inserting it or if the remaining
battery charge is too low.
38
UNABLE TO RECOGNIZE
THE RECORDING MODE
OF THE DISC
The disc may not be recognized by this camcorder if it was
initialized with a different device.
–
You inserted a disc recorded in a different Television System (PAL
or SECAM).
–
D119_NTSC-E.book Page 102 Monday, December 18, 2006 10:14 AM