User Guide

4-89
CHAPTER 4 SERVICE MODE
FEED-ADJ COPIER>ADJUST
Level 3
ATT-T-A
ATT-T-B
RG-XA
RG-XB
RG-Y
TR-DLY-A
TR-DLY-B
ATT-CHK
ATT-ON
RGST-CHK
RGST-ON
TR1-CHK
TR2-CHK
TR1-ON
TR2-ON
TR-END-A
TR-END-B
Remarks
-10 to +10
Unit: 0.4 mm
-47 to +47
Unit: 0.06 mm
-70 to +70
-10 to +10
Unit: 0.4 mm
1: 2-sheet retention (sides B
and A)
2: side A retention
3: side B retention
OK key to start; auto stop
1: 2-sheet retention (sides B
and A)
2: side A retention
3: side B retention
OK key to start; auto stop
OK key to start; auto stop
0 to 25
Unit: 0.4 mm
Executes test printing at TR2-
ON.
Description
Use it to enter a transfer drum side A attraction
timing adjustment value.
Use it to enter a transfer drum side B attraction
timing adjustment value.
Use it to enter a registration (point of attraction)
fine-adjustment value for transfer drum side A sub
scanning direction (feeding direction).
Use it to enter a registration (point of attraction)
fine-adjustment value for transfer drum side B sub
scanning direction (feeding direction).
Use it to enter a registration (point of attraction)
fine-adjustment value for transfer drum main
scanning direction (drum axial).
Enter a fine-adjustment value for the transfer delay
on side A of the transfer drum.
Enter a fine-adjustment value for the transfer delay
on side B of the transfer drum.
Use it to select a point of attraction on the transfer
drum during ATT-ON.
Use it to execute attraction of copy paper to the
transfer drum according to ATT-CHK settings.
Use it to select a point of attraction on the transfer
drum during RGST-ON.
Use it to execute printing for checking registration
(side of retention) using C according to RGST-CHK
settings.
Use it to select a point of attraction on the transfer
drum during TR1-ON.
Use it to select a point of attraction on the transfer
drum during TR2-ON.
Use it to execute printing for checking a 1-mm
leading edge margin according to TR1-CHK
settings.
Use it to execute printing for checking an 8-mm
leading edge margin according to TR2-CHK
settings.
Use it to adjust the falling edge (trailing edge
margin) of transfer high voltage for side A retention.
Use it to adjust the falling edge (training edge
margin) of transfer high voltage for side B retention.
• Be sure to make adjustments whenever you have
replaced the transfer drum unit.
• A lower setting will shift the point at which
blurring starts toward the trailing edge.
1: 2-sheet retention (sides B
and A)
2: side A retention
3: side B retention