User Guide

CHAPTER 13 TROUBLESHOOTING
13-92
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
18 The copy has lines (1st copy only; near 175 mm from the leading edge; A3).
Cause
------------
Transfer drum
assembly
Attraction roll
Photosensitive
drum shaft
Flywheel
Action
Replace the spacer.
Clean the attraction
roller.
Replace the scraper.
Tighten the screw.
Tighten the fixing screw.
Check to see if the
flywheel is mounted
properly.
Step
1
2
3
4
5
Yes/No
YES
YES
YES
YES
NO
Checks
Generate a halftone test print using
TYPE=5 (DENS-M/C/Y/K=25,
TXPH=0).
Is the end of the roller spacer bent?
Is the attraction roller soiled?
Is the screw on the core fixing roll
of the photosensitive drum loose?
Is the fixing screw on the flywheel
loose?
19 The copy has color displacement (magenta).
Cause
------------
Registration roller
clutch (CL9)
Attraction roller
Photosensitive
drum shaft
Flywheel
Action
Apply oil to the spring
clutch, or replace it.
Clean the attraction
roller.
Replace the scraper.
Tighten the screws.
Tighten the fixing screw.
Mount the flywheel
properly.
Set
ADJUST>MISC>ATT-
RTN3, ATT-RTN4 to
'1'.
Step
1
2
3
4
5
6
Yes/No
NO
YES
YES
YES
YES
NO
Checks
Generate a grid test print
(TYPE=6), and make a check.
Is the mechanism used to release
the registration roller operating
normally?
Is the attraction roller soiled?
Is the screw on the core fixing roll
of the photosensitive drum loose?
Is the fixing screw on the flywheel
lose?
Is the flywheel mounted at an
angle?