User Guide

COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
11-45
CHAPTER 11 INSTALLATION
12) Attach the Switch Settings label [6] to the
top cover [5], and record the settings of
the switches on the label.
Figure 11-622
13) Secure the top cover with two screws [7].
When doing so, check to make sure that
the cable of the power supply unit is
secured in place to the cable guide found
inside the unit and, in addition, it is not
trapped by the upper cover.
14) If you are connecting the Control Card
Printer A-1, connect it to the connector J4
of the copy data controller. (As necessary,
use a relay cable.)
Figure 11-623
15) Check to make sure that the cable is all
inside the copy data controller, and end
the installation work.
Attach the petty-pull [8] to the right
bottom of the copier’s rear.
16) Fix the cable connecting to the copy data
controller in place to the petty-pull.
17) Check to make sure that no cable is trapped
by the casters of the copier or the sorter.
Figure 11-624
[5]
[6]
[7]
[7]
J4
Copy data controller
[8]