User Guide

COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
7-91
CHAPTER 7 PICK-UP / FEEDING SYSTEM
3) Peel the adhesive tape from the adhesive
tape from the leading edge (where holes
are found) of the transfer drum sheet.
4) Match the holes along the leading edge of
the transfer drum sheet with the holes in
the ring connecting plate, and attach the
leading edge of the sheet.
Figure 7-845
5) Peel off the adhesive type of the transfer
drum sheet.
6) Holding the trailing edge of the transfer
drum sheet with your right hand, rotate the
ring at the front of the transfer drum by
your left hand while letting the sheet
down on its own weight.
Figure 7-846
Caution:
When the entire area of the transfer
drum sheet has been attached, check to
make sure that the discrepancy between
the leading edge and the trailing edge of
the transfer drum sheet is 0 ±1.5 mm.
Figure 7-847
Leading edge of sheet
Trailing edge of sheet
0±1.5 mm or less
7) While keeping the leading edge of the
transfer drum sheet down, even out the
sheet by rubbing it from the center to the
sides.
Figure 7-848