User Guide

Selecting the Film Adapter Unit

The Scan from setting in the Prefs. tab cannot be used to select the Film

Adapter Unit as an image source. Follow the procedure below to select the

Film Adapter Unit for use with your system.

1. For [Scan from] in the Prefs. tab, select [Platen].

2. Click the [Easy Scan] check box off.

3. Start ScanGear Toolbox CS and click the button such as Copy or Custom to

open the TWAIN driver display. For any setting other than when [Show

Toolbox] is selected under [When Scanner Push Button pressed], you open

the TWAIN driver display by pressing the Start button on the front of the

scanner.

4. In the TWAIN driver, select the Film Adapter Unit for the image source. If

you are using ScanGear CS, click the Scanner tab (the tab with the name

of the Scanner) and select the image source on the Scanner sheet in the

Advanced Mode. You can select the image source also in the Simple

Mode.

5. Use the TWAIN driver to execute previewing or scanning images.