Manual

Canon MultiPASS C50 Getting Started ENGLISH
II-23
Message Error Code Cause Action
DOC TOO LONG #003 It took more than 32
minutes to send or
copy a document.
Divide the document and
send or copy each part
separately.
It took more than 32
minutes to receive a
document.
Contact the sender, and
have them divide the
document and send each
part separately.
The document is longer
than 1 metre.
Use a copy machine to
copy each page of the
document and send the
copy.
DOCUMENT READY – The document in the
Automatic Document
Feeder (ADF) is ready
for scanning.
Send the fax, scan the
document, or make a copy.
ECM RX – The MultiPASS C50 is
receiving a fax using
ECM.
Faxes can take longer to
receive when using ECM.
Try turning ECM off if you
need to receive quickly, or
if you know your local
telephone lines are in good
condition.
ECM TX – The MultiPASS C50 is
sending a fax using
ECM.
Faxes can take longer to
send when using ECM. Try
turning ECM off if you
need to send quickly, or if
you know your local
telephone lines are in good
condition.
HANG UP PHONE – The handset is off its
hook.
Place the handset properly
onto its hook.
INSTALL BC-21 – The BC-20, BC-22/22e,
or BC-29F BJ
Cartridge is installed.
Remove the BC-20, BC-22/
22e, or BC-29F BJ
Cartridge and install the
BC-21/21e BJ Cartridge.
INSTALL BC-21/20 – The BC-22/22e or
BC-29F BJ Cartridge is
installed, so the
MultiPASS C50 cannot
print any received
faxes, or make copies.
Remove the BC-22/22e or
BC-29F BJ Cartridge and
install the BC-21/21e or
BC-20 BJ Cartridge.
LOAD PAPER – The MultiPASS C50 is
out of recording paper.
Add paper to the sheet
feeder. Make sure the
stack is below the limit
mark (
). Then press
the
(STOP) button.