User Guide

Part 3: Operating Instructions
BJC-2000
3-11
1.5 Paper Settings
For optimum printing, the printer has various paper settings to suit various types of
paper. Set the paper selection lever before loading the paper.
1.6 Banner Printing
When printing on banner paper, remove the paper support and set the paper delivery
flap to the upright position. To avoid misfeeding, put a light crease between the first
and second page and set the first page in the sheet feeder. Place the rest of the banner
paper behind the printer. Each top margin for banner printing is set at 0mm.
However, to avoid printing on the platen, printing will start 3mm from the initial top
margin. Set an extra sheet at the end in case the bottom edge is not printed on the
last page.
Banner printing uses a large amount of ink. To avoid ink shortage, use of a new ink
cartridge when printing banners is recommended.
Banner Paper
Paper Delivery Flap
Output Tray Extension
Figure 3-13 Banner Printing
Media Thickness Lever
Paper Feed Flap
Method Limit Position
Plain paper Left Sheet feeder 5 mm Flat
High resolution paper Left Sheet feeder 5 mm Upright
Envelopes Right Sheet feeder 5 envelopes Flat
Transparencies Left Sheet feeder 20 sheets Upright
Back print film Left Sheet feeder 10 sheets Upright
Glossy photo paper Left Sheet feeder 1 sheet Upright
Banner paper Right Sheet feeder 1 sheet Upright
Fabric sheet Right Sheet feeder 1 sheet Upright
High gloss film Left Sheet feeder 1 sheet Upright
TABLE 3-1 QUICK REFERENCE FOR SETTING