User's Manual

Table Of Contents
Specifying Common Settings
4-37
4
Customizing Settings
Energy Consumption in the Sleep Mode
You can set the amount of energy that the machine consumes when it is in the
Sleep mode.
NOTE
The machine may not enter the Sleep mode completely, depending on the status and
type of installed MEAP applications (e.g., there still may be applications running in the
background consuming power).
If there are less than 10 minutes remaining before a Delayed Send job is to be sent, the
machine will not enter the Sleep mode completely.
If you are using a management application to view or manage the settings and status of
the machine via the network, the machine may not enter the Sleep mode completely.
If you are using the machine as a Windows printer, the machine may not enter the Sleep
mode completely if SNMP Status is enabled for your operating system (unless your
computer is turned OFF). For more information on disabling SNMP Status, contact your
network administrator.
In some cases, the energy consumption level in the Sleep mode is 'High' even when the
energy consumption level is set to 'Low' when:
- A job is being processed (including a forwarding job, report job, receive job, and
sending a forwarding done notice).
- The optional imagePASS is installed.
- Any of the following settings are set from the Additional Functions screen:
*1 If there is more than 10 minutes remaining before the specified time, the machine consumes the same amount
of energy as when the energy consumption level is set to 'Low'.
Report Settings
Settings Send The Daily Activity Report Time setting for
the Activity Report is set to 'On'.
*1
Fax The Daily Activity Report Time setting for
the FAX Activity Report is set to 'On'.
*1
System Settings
Communications
Settings
Memory RX Inbox
Settings
Time limit for receiving fax documents in
memory is set.
*1
Network Settings TCP/IP Settings Use IPv6 is set to 'On'.
DHCP is set to 'On'.
NetWare Settings NetWare is set to 'On'.
AppleTalk Settings AppleTalk is set to 'On'.
SMB Server Settings SMB is set to 'On'.
E-Mail/I-Fax The POP Interval setting is set to fewer
than '10' minutes. (Excluding when the
POP Interval is set to '0'.)