Rod Holder and Downrigger Trolling System Owner's Manual

3
1904000 Deck Mount
The Cannon Deck Mount plate is a four inch by three inch clear
anodized aluminum plate which allows the hard mounting of Cannon Dual
Axis Rod Holders. The plate comes with a black protective mounting boot
and all mounting hardware.
1904015 Rail Mount 3/4” to 1-1/4”
1904016 Rail Mount 1-1/4” to 2”
Cannon Rail Mounts allow for the mounting of Cannon Single and Dual
Axis Rod Holders to round or square rail. Two sizes are available for round and
square tube styles. Components are made from clear anodized aluminum and
stainless steel for strength and corrosion resistance.
1904020 Clamp Mount
Cannon Rail Mounts allow for the mounting of Cannon single and
dual axis rod holders to any transom or allowable clamping edge.
Clamp opens to two and a half inches and is made from clear anodized
aluminum and stainless steel for strength and corrosion resistance.
1907022 Adjustable – Downrigger Mount Rod Holder - Metallic
1907023 Adjustable – Downrigger Mount Rod Holder - Black
The Adjustable – Dual Axis Rod Holder is also available on a Cannon
downrigger mount in a metallic or black finish (metallic finish shown right).